Hook up subwoofers to factory radio
Speaker wires tend to be grouped together, so look for what may be pairs to start testing. Ditto what MacLeod said!
I like to bring the sub's volume up to the point where I just start to hear the bass filling out the speakers' sound, but some listeners prefer more pronounced bass fullness.
Car Audio Defined By A Chick
The wires are not grounded properly, check to make sure the surface is clean, unpainted metal. Hope to hear a response.
Do I really need a toggle for this? Hide all of the cables and wires behind carpeting, panels or trim for a cleaner and more professional look.
Introduction: Adding RCAs to a Standard Car Head Unit
When I play the radio the sound is low, lacks bass, cannot enjoy it at all. Otherwise you can just undo the plug from the converter and then the back of the head unit. If you have a stock stereo and hook up hydroponics merced have the remote wire there you want to in twine the remote wire with the power wire before inserting in the power slot for amp.
But my question is, i just bought an infinity reference a amp and want to hook it up but not sure what kind of subwoofer i will go good with it? Hope that make sense and I best place hook up vegas your question correctly! I can understand wanting to keep the look stock. I am hooking up after market amp in range rover and have loc converter got to factory sub but has four wires red and black also green and grey on the other side which ones do I hook up to to get bass for after market subs.
Get the remote wire in your wiring kit.
FYI its a ram with a line out converter and aftermarkyamp already in place. Oh well, you can just pull the radio and tag the speakers there, you'll have to get an ignition source for the remote wire and its all behind the radio.
Ensure the ground hook up subwoofers to factory radio connection is to bare metal. June edited June Additionally I would get a bass knob so you can have an independent sub level volume control as opposed to adjusting the bass on the head unit which will adjust bass levels to all speakers. Not all stereo systems can power to 2ohms without simply burning over the circuits.
When you have a rough idea where you hook up subwoofers to factory radio be mounting your converter unit, solder on the extra wire you'll need to reach your head unit cables and insulate them with electricians tape or heat shrink tubing.
Please read our Comment Policy before commenting. Don't forget to test your rem wire before you assume it campsite hook up plug. If this is the case, bare the wires back just the right length to suit the depth of the connection sockets.
The amount of space you have to work with will help determine the size amp you buy. If you use the PAC LP with signal sensing remote turn on, the line output convertor itself will give you a remote turn on lead.
That means you have to double up the connections on the receiver or amplifier see photo below that illustrates that connection method.
Step 1: Bits and Tools
Can I connect the line out converter of my car stereo to the sub instead of taking apart my dash unit? The fuse amperage should match the gauge size. You should be able to connect it to the auxiliary on the back of the stereo unit. It has a Harmon Carmen premium system.
For adding casual hook up boston woofer you need adapter that converts speaker output into RCA connections. Hi David, Yeah, definitely tap your audio signal off any stock subs in the vehicle.
Share your voice
If you're short on wiring, either order more or locate the amplifier to suit the wiring that you have. Tape up your scotch blocks to stop them rattling around and to keep the cables bundled up neatly.
Plug your RCA leads, speaker leads and remote turn-on lead from the amp into the back of the head unit. Your only wiring options are running each subs voice coils series, then parallel the subs for a final 4 ohm load or wire the voice coils parallel, then parallel the subs for a final 1 ohm load.